What problems can we fix ourselves?
1. The contact surface between the fixed ring and the moving ring of the internal mixer is uneven, and a sealing oil film cannot be formed.
We can dismantle the internal mixer and check the fixed circle. If the drag contact surface is not damaged, but the contact rate is low, it needs to be run-in. The running-in time is more than 4-8h, and the contact surface cannot be cut off during running-in.
2. There are hard particles between the mixing motor ring and the fixed ring, which will strain the contact surface, so that the contact surface cannot form a sealing oil film
3. The alloy of the internal mixing motor ring falls off
Just replace the moving coil, and then run the fixed moving coil for a few hours to solve the problem
Kind tips:
If your mixer equipment fails, be sure to check the cause of the failure, try to ask professionals to repair it, and do not disassemble it without permission!The above is the information about the internal mixer. If you want to know more about our company's news or products, you can consult us. We also sell Dispersion Kneader, Rubber Internal Mixer, Rubber Open Mill, Two Roll Mill, Plastic Granulator and Extrusion Pelletizer.
